7 points to Get to Know UV Coating Machine

The UV coating machine is small equipment manufactured for the digital printing, color and short run printing. It can coating on the surface of photo, plastic, coated paper/ art paper, gold leaf, silver leaf, PVC, PET, canvas, compact disc, gum stock and so on, and the result is waterproof, defend oil smooth, wear-resisting, beautiful in color. It is used for full coating to enhance their quality and give beautiful feeling.

For printing, carton enterprises, selecting UV coating machine with excellent structure, stable performance, easy operation, high production efficiency and energy saving is of important significance. Therefore, the correct knowledge and understanding of the structure and features of the polishing equipment is essential to improve production efficiency and product quality.

Coating Machine Operation Manuals

1. Open the carton and take out the machine, put the machine on the level desk, then set up the four rubber foots from the white pocket on the bottom of machine , the other four on the small paper stock.

2. Open the upper cover of the machine; snip the cable tie to make the belt in parallel statement, then the machine can normally operate very well.

3. Pour UV Liquid into the box, liquid depth not exceed 1.5cm. Push the box under the rollers, and then put the pipe in the box.

4. Get through the power line; turn on the three switches (right for power、middle for UV light、left for circulate pump of liquid). The ray of UV light change from dark to bright, it will takes around 3 minutes, and the UV liquid should flow the rollers fully, after that you can coating now.

5. First time to use the machine, there is any atmosphere in the pump, so you may find there is no UV liquid overflow after the machine work 3-5 minutes. At this moment, you just need to use a syringe to suction air from the outer tube.

6. Put the photo or any other materials which you want to coat between the stock, notice, the coating side is up，then push the photo under the rollers, the photo coated will come out from the back of the machine, so you have finish the coating.

7. If you fell the liquid on the material coated is too thin or too thick, you can adjust the gap between the rubber rollers on the base of your need. First, open the small cover above the rollers, you can see two pieces of aluminum which are in front and both ends of the rollers, it is controlled by screw. Second, use the socket head wrench and adjust clockwise, the gap between the rollers could get small, coating thin; adjust anticlockwise, gap get large, coating thick.