Bench lathe remanufacturing revealed huge potential

As an emerging industry, green remanufacture engineering is a type of recycle suitable for ecological and economical requirements. Remanufacturing is not the same as refurbishing a product, which merely replaces the degraded parts.

Rather, it’s like “bringing the odometer back to zero,” Nasr explains. In reman, a product is completely disassembled, with as many components as possible—ideally all of them—salvaged and cleaned to a good-as-new state. The newly enhanced parts are then reassembled into a born-again product. For lots of goods, it’s a process that can be repeated many times over.Remanufacturing represents perhaps the largest untapped resource for productivity improvement in American industry.

By using waste machine recycling in good casting, bench lathe can be sent back to the factory technical reform to make a roll, the operation accuracy and service life is as same as a new machine.

China is the world manufacturing power, is also machine power, the current domestic bench lathe has about 8 million, already for seven years the world consumption machine. According to the international on the attrition rate of 3% per year, nearly 240000 bench lathe into the selection procedure, accounting for half of the domestic production of the new machine around. 

If make full use of the waste of the bench lathe, column, such as casting, and carries on the repair transformation, can save 60% of energy consumption, save 70% of the costs, reduce the pollutant emissions 80% above, so as to realize the production cycle.